Sega The House Of The Dead 4 29"STD, Руководство пользователя

Страница: 22 / 68

7. PRECAUTIONS WHEN MOVING THE MACHINE
When moving the machine, be sure to pull out the plug from the power supply. Moving the machine with the plug still inserted can cause the
power cord to be damaged, resulting in a
fi re and/or electric shock.
When moving the machine on the fl oor, retract the adjusters, and ensure that the casters make contact with the fl oor. Pay careful attention so
that the casters do not run over power cords and earth wires. Damaging the power cords can cause an electric shock and/or short circuit.
When moving across an area with a sharp difference in height
fi rst separate the cabinet and ASSY DIP. Tilting them whilst the two are still
joined together may damage the connectors and could cause injury.
When lifting the cabinet, be sure to hold the handles and the bottom part. Lifting the cabinet by holding other portions may damage parts and
installation portions due to the empty weight of the cabinet, and may cause personal injury.
When moving the ASSY DLP, do not push it from the rear side. Push it from sideways. Pushing the ASSY DLP from the rear side can have
the ASSY DLP fall down, causing personal injury, etc. In case the
fl oor has slanted surfaces or step-like differences, be sure to move the
machine by 2 or more persons.
When the cabinet and ASSY DIP are not connected the cabinet is unstable on its own. Pushing it may cause it to fall over.
When detached always keep the cabinet on a level surface and make sure it does not start to lean to the left or right whilst working on it.
Do not hold or press the plastic parts as indicated by the Figure. Failure to observe this instruction may break the parts, and eventually the
broken pieces may cause a personal injury.
When moving the cabinet do not hold or push the gun holders. This could deform their shape or cause damage to them.
Never push on the projector’s screen. The screen is easily damaged but cannot be repaired. If damaged the entire screen must be replaced.
FIG. 7a
Have caster make contact with the floor.
FIG. 7b
Separate the cabinet and ASSY DLP when
moving over a slope or up/down steps.
Note for 52”/62”DX
(Picture is 62”DX)
Pushing the ASSY DLP from the back may
make it fall over. Always push it from the side.
17