Sega SONIC DASH EXTREME, Руководство пользователя

Страница: 87 / 160

74
CONTROL
UNIT
10
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
• Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of fi re.
• Exercise due caution in performing soldering work. If soldering iron is handled
carelessly, there could be fi res or burns.
• When fastening plastic parts, be careful not to tighten screws or nuts excessively.
If these are tightened to excess, parts could be damaged, resulting in injuries
from fragments, etc.
• After the unit has been disassembled and reassembled again, check carefully
that the unit has been reassembled correctly.
• Once the product has been disassembled, use slack preventive agent. Coat
screws with suitable amounts of this agent and then tighten them. If this agent is
not used, the product might start rattling or come apart.
• Use the slack preventive agent prescribed in these instructions. If any other
agent is used, there could be chemical changes that inhibit the use of screws
and part surfaces could be damaged.
• Be careful not to damage or lose small parts or screws.
• When a part has been replaced, be sure to always make adjustments and
check conditions in Test Mode.
10 CONTROLLER UNIT(S)