Sequencer COMPACT
Technical brochure
FI 72.0467.0118E
Page 12 / 42
USER INTERFACE
Main Page / Synoptic
1: Informations about sequencer / state of the declogging cycle:
n° : Number of the last activated solenoïd valve ( SV )
T: x / y: x is the countdown time / y is the running time
If one touches this area: link towards informations display sequencer z
2: Display of load loss measure « dP » (daPa)
If one touches this area: link towards measure display « load loss
dP ».
3: If press this area: link towards page « main menu ».
4: Display of the trend of dust emission during X minutes, % of the adjusted alarm threshold (see instruction CDM).
If one touches this area: link towards informations page of CDM / Measure of dust rate.
This display is ON only if a dust sensor has been validated into parameters.
Configuration of the dust sensor is available on Parameters Menu « Dust Sensor CDM »
5: Display of the value on analog input 4/20mA.
This value comes from the device which is connected to the analog input of the sequencer.
If one touches this area: link towards graph of analog input measure.
This display is ON only if an input has been validated into parameters.
Configuration of the 4-20mA signal is available on Parameters Menu « Analog Input »: name, unit…
6: Display of current protection level.
7: Indication about the state of the 4 inputs (see chapter about definition of inputs) :
•
Running order
•
T2A
•
A/C presence
•
Forced run
Green spot = the input is present /
Gray spot = the input is absent
2
1
3
7
4
5
6
