7
Listen to the phono
Noted:
-
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before
operating and re-secured again afterwards.
-
Be sure that the Aux-in jack (11.) is not being connected during the phono
operation (see below point 2 of the remark).
1. Press the On-Off/Function button (6.) to turn on the unit and press it again
until the LED display (2.) shows “ PH
“ (Phono).
2. Set the speed selector (17.) to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor (16.) if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will
start to rotate.
5. Place the tone arm by the pick up holder to the desired position of the record.
6. Adjust the volume (13.) to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the tone arm from
the record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
Remark
:
1. As some kind of record the auto-stop area was out of the unit setting, so it will stop before the last track finish.
In this case, select the auto-stop switch (18.) to “ off “ position, then it will run to the end of the record but will
not stop automatically (turn off the unit by press and hold the
On-Off/Function button (6.) for 2-3 seconds,
or
switch back the auto-stop switch to “ on “ position to stop the platter rotate). Then put back the tone arm to
the rest position.
2. The Phono mode and the AUX-in mode are sharing the same function mode and once the Aux-in jack
(11.) is plugged in, it will automatically switched to Aux-in mode from Phono mode. So, please be
ensured that the Aux-in jack is not being connected if you want to playback the record.
Aux-in connection
Connect the unit to any auxiliary device (i.e. MP3 player, or iPod® (not included) by connecting the aux in jack (11.)
with one end of 3.5mm stereo cable (not provided) and the other end connect to the auxiliary device to perform the
music.
1. Plugged the Aux in jack from your external device.
2. Press the On-Off/Function button (6.) to turn on the unit and press it again
until the LED display (2.) shows
“ AUX ”
mode.
3. Start to playback your device and adjust On-off/Volume knob (13.) to the desire volume level. If the distortion
was too high, reduce the volume level of your auxiliary device.
Playback of MP3 song via USB storage media
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media
with USB connector (not supplied). Plug in the USB pen drive to the USB socket (12.).
Connecting the USB upside down or backwards could damage the audio system or
the storage media (USB thumb drive). Check to be sure the direction is correct before
connection.
1) Plug in the USB drive with the USB symbol
facing upwards, making sure it is fully
inserted.
2) Press the On-Off/Function button (6.) to turn on the unit and press it once again and the
LED display (2.) will show “ Lod ”.
3) The system will start reading the storage media after connecting and will show the total number of folders or
tracks on the LED display (2.) after read.
4) The system will start playback automatically. You can press the Play/pause
button (15.), Skip up
or
Skip down
(4.) button to control the music playback.
5) Adjust the volume (13.) to the desired level.
