Step 26 — X Tower Motor Connector
The X tower motor connector (black 4-pin red, green, yellow, blue wires) will install in the X stepper
position on the board.
Plug the connector in so that the smooth flat side of the black connector is facing the outer edge of
the Duet.
Clean up the excess wire with a zip tie. Make sure the wires aren't near where the fan from the top
silver cover of the top assembly will end up, you don't want the wires getting stuck in the fan later.
Step 27 — Remaining Motor Wires
Repeat previous steps with the remaining two tower's wires. Use the diagram to make sure you're
plugging them in to the correct positions.
Assembling Artemis 300
© 2018
seemecnc.dozuki.com/
Page 23 of 40
