LCQ / LCS / LCQI / BMQ / CPQ / TBQ / TBS / TBQI / TBSI
|
3
You may then press the button to
switch between COOL and VENT (where fresh
air is being delivered but not cooled).
MAGIQCOOL CONTROLLER
OPERATION cont
ILL1123-A
Once COOL or VENT has been selected, the
wall control will maintain a constant fan speed.
This is indicated by the bar graph shown on
the display.
To increase or decrease the fan speed
required, press either the or
button.
Auto Mode
To select the AUTO mode press the
button until AUTO is shown on the display.
In AUTO mode the cooler will remember the
last setting used. Press the button if
you require more cool air or the button
if you require less. Don’t alter the setting
however, until the room temperature has
stabilised.
MAGIQCOOL CONTROLLER
OPERATION cont
Delayed Start or Stop
The cooler can be programmed to start at a
specific time or stop at a specific time.
The delayed start time can only be
programmed when the cooler is OFF. To
program the cooler to start in a certain amount
of hours use the following sequence:
Programming In Manual Mode
(1)...... Press the button.
(2)...... Press the button until MAN is
displayed on the screen.
(3)...... Press the or button
until the desired fan speed is displayed by the
bars in the middle of the screen.
(4)...... Press the button to set either
COOL or VENT.
(5)...... Press the button and the ‘starts
in’ time will start flashing.
Use the and buttons to select
the desired time.
(6)...... Press again.
ILL1123-B
ILL1124-A
ILL1118-A
