Attach this information to a wall near the AIRA heater.
Read the Installation, Operation, and Service Manual thoroughly before installation, operation, or service.
Know your model number and installed configuration.
Model number and installed configuration are found on the burner and in the Installation, Operation and Service Manual.
Write the largest clearance dimensions with permanent ink according to your model number and configuration in the open spaces below.
OPERATING INSTRUCTIONS
1.
STOP! Read all safety instructions on this information sheet.
2. Open the manual gas valve in the heater supply line.
3.
Turn on electric power to the heater.
4. Set the thermostat to desired setting.
TO TURN OFFTHE HEATER
1.
Set the thermostat to off or the lowest setting.
IF THE HEATER WILL NOT OPERATE, TO ENSURE YOUR SAFETY,
FOLLOW THESE INSTRUCTIONS TO SHUT DOWN YOUR HEATER
1.
Set the thermostat to off or the lowest setting.
2. Turn off electric power to the heater.
3. Turn off the manual gas valve in the heater supply line.
4. Call your registered installer/contractor qualified in the
installation and service of gas-fired heating equipment.
AWARNING
Fire Hazard
Keep all flammable objects, liquids and vapors the minimum
required clearances to combustibles away from heater.
Some objects will catch fire or explode when placed close to
heater.
Failure to follow these instructions can result in death, injury
or property damage.
Maintain
clearance
to the side and
clearance below
the heater from vehicles
and combustible materials.
Aira
Ply
Ltd
-
Head Office
144 Colchester Road
Kilsyth, VIC 3137
Telephone: 61 3 9839 8000
Fax: 61 3 9761 4732
Aira Pty Ltd
-
New Zealand
Unit B, 50 Keeling Road
Henderson, Auckland
Telephone: (09) 835 2100
Fax: (09) 835 2201
Installation Code and Annual Inspections:
All installation and service of AIRA equipment must be performed by a contractor qualified in the installation and service of equipment sold and supplied by Aira and conform to all requirements
set forth in the AIRA manuals and all applicable governmental authorities pertaining to the installation, service, operation and labeling of the equipment. To help facilitate optimum performance and
safety, Aira recommends that a qualified contractor conduct, at a minimum, annual inspections of your AIRA equipment and perform service where necessary, using only replacement parts sold
and supplied by Aira.
Further lntormalion: Applications, engineering and detailed guidance on systems design, installation and equipment pertormance is available through AIRA representatives.
Please contact us for any further information you may require, including the Installation, Operation and Service Manual.
This product is not for residential use.
© 2014 Roberts-Gordon LLC
All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied in any form or by any means - graphic, electronic, or mechanical, including photocopying,
recording, taping, or information storage and retrieval systems - without written permission of Roberts-Gordon LLC.
P/N 91037912-AH
Orig
