Release Version 1.1
6
4. Application Diagram
4-1. When connecting a PoE IP Camera (Tx’s PoE Switch must be ON)
<Installation Guide>
① Set the CAMERA PoE switch on the transmitter to ON. (PoE LED on)
※ If you are connecting a non-PoE camera, set the CAMERA PoE switch on the transmitter to OFF.
② After you have connected an IP CAMERA to the transmitter, connect the transmitter and the receiver
using a UTP cable.
③ Connect UTP cable connected to Transmitter to Receiver. Connect Receiver to NVR or PoE Hub.
④ Check the transmission distance and set the Bandwidth switch of the receiver to the corresponding
transmission speed.
※ 10M: Transmit by 10Mbps (10Mbps over CAT.5e : 800m).
※ 100M: Transmit by 100Mbps (100Mbps over CAT.5e : 500m).
⑤ Supply power by connecting DC Adapter (48V or 56V) to the DC Jack of the receiver.
⑥ Check the camera's video on the monitor connected to the NVR.
※ If it is connected correctly, the LINK LED on Tx and Rx lights up and the ETH LED flashes.
CAMERA PoE switch
OFF
Transmitter as OFF
Transmission Distance over UTP cable (CAT.5e):
10Mbps-800m & 100Mbps-500m
Tx
Rx
