SEDONA OP-PECFT5836-SED, Руководство по сборке

Страница: 16 / 63

WARNINGS
&
USE PROPANE GAS ONLY!
• Do not store or use gasoline or other flammable vapors in the vicinity of this
or any other appliance.
• Service must be performed by a quality installer, service agency or the
gas supplier.
• For use with cylinders marked PROPANE only. DO NOT connect to
a remote gas supply.
• If the fire table is stored indoors, detach and leave propane cylinder
outdoors.
&
WARNING!
• Do not use this fire table for cooking.
• Do not burn any other materials than are supplied with and intended for use in
this fire table.
• Do not pour water into the fire table.
• The maximum inlet gas supply pressure is 250psi.
• The appliance must be isolated from the gas supply piping system by closing its
individual manual shutoff valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than ½ psi(3.SkPa).
• The installation of this product must conform with local codes or, in the absence
of local codes, with either the National Fuel Gas Code, ANSIZ223.I/NFPA 54 or
CAN/CGA-B149.1, National Gas and Propane Installation Code.
• Do not use this appliance if any part has been under water.Immediately call a
qualified service technician to inspect the appliance and to replace any part of
the control system and any gas control that has been under water.
• Do not store a spare or disconnected propane cylinder under or near this
fire table.
• After a period of storage and/or non-use, the propane fire table should be
checked for gas leaks and burner obstructions before use.
• Properly locating the gas hose including locating the hose out of pathways where
people may trip over it or in areas where the hose may be subject to damage.
• Inspect the hose before each use of the appliance. The hose assembly must
be replaced prior to the appliance being put into operation if there is evidence
of excessive abrasion or wear, or if the hose is damaged and the replacement
hose assembly shall be that specified by the manufacturer.
• The burner must be replaced prior to the appliance being put into operation if
it is evident that the burner is damaged and the replacement burner shall be
that specified by the manufacturer.
16