INSTALLATION MANUAL AND USERS GUIDE
Multi Split Series – Ductless Split – Cassette Indoor unit
04006020101
© Sedna Aire Europe GmbH
19
10/2012
Orientate the cover panel so
that the swing flap motor lies
in the same corner as the
refrigerant pipes
(1) Mount the panel temporarily
on the indoor unit. Hang the
latch over the hook which is
on the opposite side of the
swing flap motor
(2) Hang the other 2 remaining
latches to the hooks. Be
careful not to let the swing
motor cable caught in the
sealing material
(3) Screw the 4 hexagonal
head screws under the
latches about 15mm in. The
panel rises.
(4) Adjust the panel by turning
it along the arrows shown
below so that it closes all
gaps
(5) Tighten the screws until the
sealing material between
panel and indoor unit is 5-8
mm thick
Make sure no gaps between ceiling and cover panel occur. They are critical and can deteriorate much the
cooling capacity due to air flow bypasses
Wire the cover panel with indoor unit (Swing flap motor and display
Raise indoor unit by screwing nuts on hanging
rods through holes in pane. Make sure you don’t
harm any connections
Avoid gaps !
Body
Panel
Hook
Latch
Refrigerant pipes
Swing flap motor
Body Panel
