Security Tronix ST-PTZMINI-IR10X, Руководство по установке

Страница: 8 / 17

8
Basic Function
Controlling the dome’s position (PTZ)
The dome responds to standard PTZ controls UP, DOWN, LEFT, RIGHT and ZOOM to position the
camera toward a subject to observe. The camera supports PROPORTIONAL ZOOM which will cause
the pan and tilt functions to operate at lower speeds when the camera is zoomed to the maximum setting
(10X optical zoom). Proportional zoom can be disabled in the OSD menu if desired.
Zoom
The camera provides 10X optical zoom magnification to aid in viewing objects which are further away
from the camera.
Use the controller’s ‘ZOOM TELE’ or ‘ZOOM +’ or similar to increase the increase
image magnification. Use the controller’s ‘ZOOM WIDE’ or ‘ZOOM -’ or similar to decrease image
magnification for a wider image area.
Focus
The camera supports both AUTO - FOCUS and MANUAL - FOCUS functions. The default is AUTO
focus. Operating the controller’s FOCUS NEAR and FOCUS FAR controls will temporarily override
the AUTO FOCUS function. As soon as any PTZ command is received, the camera will revert back to
AUTO-FOCUS.
Preset Point
This camera will respond to all standard Pelco preset commands. Please refer to your PTZ
controller or DVR instruction manual for specific instructions regarding how to set, call and clear
preset points.
NOTE: Some preset points are reserved for special functions, as noted below.
Special Function Presets
The follow presets are predefined for special functions.
Use your controller’s “Call Preset” procedure
to perform these functions:
PRESET FUNCTION PRESET FUNCTION
33 Pan 180 º from current position 85 Force on NEAR light
34 Reset Camera 91 Start A-B Scan (Left-Right Scan)
75 Call Pattern 1 92 Set left point of A-B scan
76 Call Pattern 2 93 Set right point of A-B scan
77 Call Pattern 3 94 Close OSD menu
78
Call Pattern 4 95 View OSD menu
81 Set Day/Night to AUTO 96 Call Tour 3
82 Switch to night 97 Call Tour 2
83 Switch to day 98 Call Tour 1
84 Force on FAR light 99 Begin 360° scan