USER MANUAL
SAFETY INSTRUCTIONS
Please carefully read the following safety instructions to avoid personal
injury and preve
n
t the NVR and other connected devices from being damaged.
1. Power source - Only use the included 48 volt (POE rated) power supply for 4 and 8
channel units, or 3 prong AC cable included with the 16 channel unit
Never operate the equipment with an unspecified power supply.
2. Never push objects of any kind through the ventilation openings of the NVR
3. Do not place the equipment in a dusty area
4. Do not place the equipment in a wet or humid environment
5. Keep the surface of the equipment clean and dry
Use soft damp cloth to clean the outer case of NVR (do not use liquid aerosol cleaners)
6. Do not operate if unusual symptoms are found
If any unusual smells or sounds are detected, unplug the power cable and contact
technical service at 1-800-774-0284.
7. Do not remove the case / cover
No user serviceable parts are inside. Please contact technical service for assistance in
upgrading or replacing the hard drive.
9. Although rarely required, when replacing the clock back-up lithium battery, use the
same part number included with the unit.
WARNING
: Disconnect the power supply before replacing the standard 3V lithium battery
on the main board. Dispose of old battery via an approved recycle facility.
10. Keep the NVR well ventilated
The NVR includes a hard disk drive and control board that produce heat during
operation. Do not block the ventilation openings (on the top, bottom, both sides and the
back side) to allow cooling during operation. Install the NVR in a well ventilated area.
11.The included power supply can only be used for one NVR. Do not connect
additional equipment to
the sup
ply.