24
has been activated.
10. RELAY OUT TIME: Press the
«
ENTER
»
button to adjust the relay output time 1 –
30 seconds. continuous (CONT), or off. Note: Pressing any button will stop the relay
after it has been activated.
8.5.1 SENSOR TYPE:
1. Cursor (>) position indicates the current selected position.
2. Press
« ? »
and
« ? »
button to move the cursor to the desired item (CH1~CH4).
3. Press the
«
ENTER
»
button to make changes.
4. Press the
«
MENU
»
button to exit “SENSOR SETUP” selection.
5. CHANNELS 1 through 4: Press the
«
ENTER
»
button to setup
“NORMAL-OPEN” (Normally Open) switch, “NORMAL-CLOSE” (Normally
Closed) switch, or “NOT INSTALLED” if no trigger device such as a motion
detector or door switch is attached
SENSOR SETUP
> CHANNEL-1
NOT INSTALLED
CHANNEL-2
NOT INSTALLED
CHANNEL-3
NOT INSTALLED
CHANNEL-4
NOT INSTALLED
PRESS (< >), THEN (ENTER)
PRESS (MENU) TO EXIT
Содержание SLD251
Страница 42: ...41 OK Start up ActiveX Control ...
Страница 58: ...57 Figure 2 Figure 3 ...
Страница 59: ...58 Figure 4 Figure 5 ...
