ASSEMBLY STEP 1
Attach the Collar to the Motor Unit
To avoid installation difficulties, do not run the
garage door opener until instructed to do so.
• Loosen the collar screws.
• Attach collar to either the left or the right side of the
motor unit. Ensure that the collar is seated all the way
on motor shaft until stop is reached (Figure 1).
• Position the collar so that the screws are facing up
(accessible when attached to the torsion bar).
• Tighten both sides of collar screws equally to secure
collar to the motor unit (12-14 ft./lbs. of torque)
(Figure 2).
NOTE:
For most installations the screws should be
facing up for easy access.
NOTE:
Do not tighten set screws until indicated.
6
Collar Scre
w
Collar Scre
w
Set Scre
w
ASSEMBLY STEP 2
Attach Mounting Bracket to Motor
Unit
• Loosely attach slotted side of mounting bracket to the
same side of the motor unit as the collar, using
self-threading screws provided.
NOTE:
Do not tighten until instructed.
NOTE:
Illustrations shown are for left side installation.
Socket
W
rench
Figure 1
RIGHT
WRONG
Figure 2
Scre
w
#10-32
HARDWARE SHOWN ACTUAL SIZE
To prevent possible SERIOUS INJURY or DEATH, the collar
MUST be properly tightened. The door may not reverse
correctly or limits may be lost due to collar slip.
WARNING
CAUTION
WARNING
WARNING
