www.securikey.co.uk
I
5
Programming.
User Programming Instructions.
1. Always perform these operations with the safe lock unlocked and the safe door open.
2.
Before closing the door, make sure all the program changes are correct.
3.
The system will not allow the user code to be set to six zeros.
Changing Code
a) Enter “0” six times. A single beep will sound, indicating the entry is valid and the system is
awaiting the code change.
b) Next, enter the existing six (6) digit code. A single beep will sound, indicating the entry
is valid.
c) Enter the new six (6) digit code. Two beeps will sound, indicating the entry is valid.
d) Re-enter the new six (6) digit code. One beep will sound, indicating the codes entered in
steps c and d are the same and the code changing process is successful.
e) If three beeps sound, the code change process has been unsuccessful. The existing code
is still valid. Repeat steps a to d.
Note:
a) Test the new code at least 3 times before closing the door to make sure the code has
been programmed correctly.
b) The system will revert to standby status if there is no key press within 10 seconds.
Standby status is indicated by two short beeps.
c) Do not forget to register your safe (page 11).
SPECIFICATIONS:：
Power Supply: DC 9V
Power Supply Range: DC 4.5V-12V
Standby Current : <50μA
Active Current: <20mA
Battery Low Voltage: 5.2±0.2V
Working Temperature: 0：~ +49°C
Working Humidity (max): <90%
Code Length: 6 Digits
Mechanical System Life Span: >100,000 Cycles
DIGITAL ENTRY PAD
