Nnn-0000nn
© Copyright 2012 SecureALL Corporation
Page
13
of
22
All Rights Reserved
7. Mount the Inside Lever Assembly (Item 3) on the Spindle with Screw. Place a spacer
(Item 6) on each Trim Screw (Figure 7a). Insert the Trim Screws (Item 8) into the Inside
Lever Assembly holes (Figure 7b). Fasten the screws until they are tight. Tighten the
Inside RF Assembly screws in Step 6. Be cautious not to overtighten any of the screws.
Work the handles and make sure there is no binding. If binding occurs, back off each of
the screws slightly until there is no binding. If binding continues, it will be necessary to
remove the chassis and widen the cutout slightly.
Figure 7a
Figure 7b
8.
Mount the Inside Cover Assembly on the Inside Lever by following the same steps as in
Step 5. Holding the Inside Cover Assembly (Item 9), in the order shown below, connect
to the printed circuit board (PCB) the three cables that are sticking through the Inside RF
Assembly and the battery box cable.
a.
Flex cable (Figure 8a) -
Figure 8a
Item 8
Flex cable
Item 9
Flex cable
socket
