2
Advance Mode
Function Description
Add device
(1)
Include any Z-Wave device into its network
Remove device
(1)
Exclude any Z-Wave device from network
Activate Learn mode
(1)
Start Learn process for inclusion / Exclusion from other network
Enter listening mode
(1)
Listen mode for sending Wakeup Notification to wake up node if configured
Broadcast device
Information
Broadcast its Node Information Frame (NIF)
Check
signal
strength
(2)
RF signal strength test using power level CC with associated node in Group 2
Outcome
Network Health
Action on associated node
3 bars
Good
No action
2 bars
Acceptable
May move node, or install repeater node in-between
1 bar
Insufficient
Must move node, or install repeater node in-between
Factory reset
Perform protocol reset, set thermostat configurations to factory default.
Note:
Please use this procedure only when the network primary
controller is missing or otherwise inoperable.
Associate Channel
(1)
Associate node in group 2 by Classic / Multichannel association, using NIF /
Multichannel capability report from other Z-Wave device (node).
Remove channel
association
(2)
Remove associated node from association group 2
View associated
channel ID
(2)
Display associated end point (Channel number ) in association group 2
Display Text
Description
None
No End point available in association group
CH x
End point x ( 1 to 127 ) available in association group
Change fuel type
(2)
Used to Set / Change boiler fuel type to configure TPI cycle.
View fuel type
(2)
View present boiler fuel type.
Lock/unlock
temperature set point
Disable / Enable set-point change using Up/Down buttons.
Role transfer
(1)
Shift primary role to the new controller in network
Exit
(3)
Exit from advance mode
1.
Maximum time out for activity is 55 seconds.
2.
Operation applicable if node available in association group 2.
SUPPORTED DEVICE AND COMMAND CLASSES
Z-Wave Device Classes
Implemented Device Class
Generic
Multilevel Sensor
Specific
Routing_Sensor_Multilevel
Basic
Portable Controller
Command Classes
Supported
Description
Manufacturer Specific
(V2)
Secure Controls (UK) Manufacturer ID, Device serial number
Version
(V2)
Provides the version number of the firmware, hardware and supported
Command Classes.
Device Locally reset
(v1)
Used to inform lifeline node that the device has been factory reset, and is
leaving the network.
Z-Wave Plus Info
(v2)
Z-Wave Plus Version 1
Role Type - ROLE_TYPE_CONTROLLER_PORTABLE_REPORTING
