Securam ProLogic L02-C, Руководство по эксплуатации

Страница: 3 / 30

ProLogic L02-C Operation Instructions
3
Followed by:
Enter a valid code to test the lock.
The Default codes are as follows:

Super Code (ID00) is 111111

Manager Code (ID01) is 123456
Upon entry of a valid code, the lock will open. If the lock does not open and the LCD screen
displays the message “Fail to Link with Lock”, repeat the reset procedure. Be sure to hold down
the reset button through steps 5-7.
If you have difficulty resetting the lock, please call SecuRam Tech Support at (805) 988-8088 or email
info@securamsys.com .
1.3 Lock and EntryPad Installation
Included within your installation kit are (2) shoulder bolts and (3) lock mounting bolts.

Install the shoulder bolts on the safe door in the pre-drilled holes above and below the spindle
hole.

Now insert the lock cable (attached to the EntryPad) through the spindle hole.

On the backside of the safe door, you will see the lock mounting plate and the predrilled lock
mounting holes.

Connect the lock cable to the lock body and position the lock body appropriately on the lock
mounting plate.

Ensure that the lock cable is positioned so that it lies in the channel on the back of the lock. This
channel is provided to protect the lock cable from damage or crimping during installation.

Using the provided lock bolts, secure the lock body to the mounting plate.
Note: it is very important to ensure that there is an adequate gap between the lock bolt and the
boltwork. This gap must be 0.125”.
1.4.1 Installing the Battery – Standard Battery Compartment (located on the back of the EntryPad)

Connect the battery terminal clip to the 9V battery. (Duracell or Energizer brands are
recommended).

Position the battery so that the terminals are in the downward position and push the battery
into the battery compartment. See Fig. 1.

Carefully tuck the excess lock cable into the cavity on the back of the EntryPad and install the
EntryPad on the shoulder bolts. See Fig. 2.