ProLogic L02-C
Operation Instructions
23
8.4 Enable Sequence
In this programming step, you can specify the order in which Lock #1 opens. By enabling “Sequence”,
Lock #1 will be designated as an outer door, while Locks 2, 3 and 4 are assumed to be operating on inner
compartment doors.
Step1: Press the Menu/OK button.
Step 2: Using the
and
, scroll to the System Menu and Press OK.
Step 3: The display will prompt you to enter a valid code. Enter either the Super Code (ID00) or
the Manager Code (ID01). The “Select Menu” message will be displayed as follows:
Step 4: Scroll UP to the menu selection “Enable Sequence” and Press OK.
Lock #1 will now always open first, even when an inner door is selected to be opened. Lock #1
will open and then 10 seconds later the selected inner compartment lock will open.
9.0 Data Management
As a security measure, all data that is transmitted between the EntryPad and lock is encrypted, such as
User codes, etc..
9.1 Encryption Key Set
The ProLogic L02-C sends and receives data to the lock in an encrypted form. This is a security measure
to ensure that all data is protected. The Encryption Key is set during the manufacturing process with a
default encryption key value. This value can be changed using the Encryption Key Set menu selection.
**Note: If the Encryption Key is changed from the default setting, this value must be maintained, as it is
a vital element to communicate with the lock inside the safe.
Step1: Press the Menu/OK button.
Step 2: Using the
and
, scroll to the System Menu and Press OK.
Step 3: The display will prompt you to enter a valid code. Enter either the Super Code (ID00) or
the Manager Code (ID01). The “Select Menu” message will be displayed as follows:
