Version 2.0
i-PAN T10 Baseboard
6 of 20
J502: USB A connector
Connector: USB-A-S-S-B-SM2-R by Samtec
The signals of the USB2.0 Typ-A connector are routed to the USB-Host port of the Trizeps
module.
The +5V supply to the USB-port are short-circuit protected and current-limited (0.75A-1.25A) by
a power-switch.
J500, J503: Ethernet connector
The Ethernet connector uses the 10/100Mbit Ethernet-interface of the Trizeps module.
Three different POE (Power-Over-Ethernet) options are available:
▪
No POE.
▪
IEEE 802.3af compatible with max. 12W output to the panel and its peripherals.
▪
A simplified version, where +12V..24V is applied to pins 7+8 and Gnd to pins 4+5 of
the RJ45 connector.
On standard a RJ45 connector is used.
Optionally a PCB terminal block for easy push-in spring connection is mountable.
Note that the PCB terminal block uses reverse pin-numbering compared to RJ45:
Pin
Signal
1
NC4 (+12..24V for simplified POE)
2
NC3 (+12..24V for simplified POE)
3
RX-
4
NC2 (Gnd for simplified POE)
5
NC1 (Gnd for simplified POE)
6
RX+
7
TX-
8
TX+
J503: PCB terminal block connector: 1771088 by Phoenix
D500: DUO LED (Link and Activity)
The LED next to the ethernet connector shows the status of the ethernet-connection:
red
- link-speed
yellow
- link-activity
J503: µSD-Card connector
This µSD-Card slot is powered by 3.3V.
Its signals are connected to the first SD/SDIO port of the Trizeps module.
It may be used to extend the storage-memory of the panel with a Micro-SD card.
