Seco EASYSHRINK 15, Руководство по эксплуатации

Страница: 14 / 26

14
PROGRAMMABLE MODES: User programms the suitable cycle, in one of the 50 files of modes PRG1 and PRG2, using the
control panel.
Mode PRG1: possibility to programm up to 25 customised heating cycles
Mode PRG2: possibility to programm up to 25 customised heating cycles
Seco Shrinkfit holders Code key
E 9304 5603 10 120
4.3.2. Selection of the heating mode
•
Selection of the required mode:
On the control panel, press key
Select the required mode using key
or (see picture below)
Then press key
to confirm your selection
Device is ready for a shrink grip or release heating cycle.
4.3.3. Using programmable modes PRG1 and PRG2
• Heating time modification
In order to prevent misuse of these modes, the modification of the heating times is secured and
an access code is required.
By security measure, heating times of PRG 1 and PRG 2 are preset to 0 second.
The access code and the procedure to modify the heating times are given on request and after
complete information about the risks.
Any change of the preset time must be made carefully, toolholder overheating makes it unusable.
In case of modification without our agreement, Seco Tools AB. cannot be held as responsible for
any damage.
Front end type
Tool fitting Ø size
E= Monobloc holder
Gauge length
Back end taper type