ENFORCER PoE Repeater
4
SECO-LARM U.S.A., Inc.
IP device doesn’t function correctly
•
Ensure that the IP camera/PoE device is functioning by
plugging it directly into the PoE switch, computer, etc.
•
Double-check that the cables were connected properly.
•
Run a continuity test on all wires in the cable
•
Equipment at both ends must be at same link speed,
10BASE-T with 10BASE-T, 100BASE-T with 100BASE-T
•
Replace with a higher-grade cable for better performance.
•
Ensure that the cable lengths are within the allowable
range and consistent with the remote PoE device power
consumption and reduce cable length as needed
•
With 1000BASE-T, power consumption is greater, so no
more than 2 POE repeaters may be used (Power
consumption of POE equipment must under 7W)
•
Plug in
•
Turn on
PoE Surge Protector
Ethernet over Coax
Ethernet Extender
Ethernet over Coax
with PoE
IPV-P188Q
IPB-A1200Q
IPB-A1100Q
NE-S103CQ
Also Available from SECO-LARM
®
:
Troubleshooting:
IMPORTANT
:
Users and installers of this product are responsible for ensuring this product complies with all national,
state, and local laws and statutes related to monitoring and recording audio and video signals. SECO-LARM
will not be
held responsible for the use of this product in violation of any current laws or statutes.
WARNING
:
Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause a
dangerous electric shock, damage the device, and void the warranty. Do not open the case of this device, as there are no
field-serviceable components inside.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2014 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
LIMITED WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in
normal service for one (1) year from the date of sale to the original customer. SECO-
LARM’s obligation is limited to the
repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is
void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM
and the purchaser’s exc
lusive remedy, shall be limited to the replacement or repair only, at SECO-LARM
’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
®
PITSW4
MiNR-P101FQ_140808.docx
