ENFORCER Rack-Mount DC CCTV Power Supplies
4
SECO-LARM U.S.A., Inc.
1.
Remove the mounting screws from the middle mounting points on the left and right sides of the
chassis.
2.
Screw the left and right mounting brackets on, facing downward.
3.
Make sure no ventilation holes are blocked when the unit is in place.
4.
Use screws or bolts (not included) to mount the unit in the desired location.
Note:
Make sure that the screws/bolts and mounting surface can support the weight of the unit.
1.
Double-check DC output voltage before connecting cameras.
2.
FOR INDOOR USE ONLY.
Do not install the unit outdoors or expose it to rain or moisture.
3.
For professional installation and use only. Installation must conform to all local codes.
4.
Avoid installing the unit near heat-generating or heat-sensitive equipment.
5.
To prevent shock, do not open the housing. There are no user-serviceable parts inside.
Installation Notes:
Mounting:
1.
Decide on a location to install the unit, away from moisture, high humidity, heat sources, etc.
2.
Make sure there is enough space around the unit so air can flow in and out for cooling
purposes.
3.
Be sure ventilation holes are not blocked by other equipment, rack housing, walls, etc.
4.
To avoid undesirable operation in either the product or other equipment place the unit at
least 12” (30cm) from any television monitor or other radiation-producing, radiation-sensitive,
or heat-producing equipment such as heaters, radiators, etc.
1.
Units may be stacked one on top of the other, or with other equipment.
2.
Make sure the rubber feet are firmly attached to the bottom of the unit and that no ventilation
holes are blocked. (See
Overview
, pg. 3)
Shelf/table mounting
Wall mounting
Mounting bracket
Middle mounting point
Bracket facing down
