9
SI1000
Operator Guide (SV62138 Rev. A)
4.
Selection Buttons and Indicator Lights
Press these buttons to step through the feeders and options
that are available on your machine.
Depending on your model confi guration, some indicator lights
and associated feeders may be inoperable. If your model
doesn’t have a second sheet feeder, for example, the indicators
associated with this feeder will not light. This is normal.
A
green indicator
shows that a feeder or function is selected for
use.
A
red indicator
shows that you selected an invalid (impossible)
combination of functions. Simply correct the error in selection and
the indicator(s) will change back to green.
An
unlit indicator
means that the feeder or function is turned
OFF.
5.
Trial Piece
After you’ve set up a job using the control panel, you
must
run
a trial piece. If you press Start before running a trial piece, the
machine display will prompt you to run a trial piece fi rst.
Press this button to run one fully collated piece as programmed
via the control panel. The envelope will not seal regardless of
whether the system has been told to seal or not. This allows
you to inspect the processed job to make sure that everything is
inserted correctly and that the address appears in the window.
The trial piece also allows the system to calibrate itself and set
its double detect feature, if selected.
IMPORTANT:
Running the trial piece is an
es-
sential
function for the machine to perform. You
must
do it before a start every time you use a
new batch of material. This allows the system to
re-calibrate in case different batches of material
vary slightly.
6.
Start
Press to begin automatic operation.
7.
Stop
Press to stop automatic operation at the end of the next cycle.
About the Sleep Mode
After 10 minutes of inactivity, the system enters a power-saving
“sleep mode” and displays
Powersave On.
Pressing any button
will wake the machine up. The machine remembers the last job
setup.
Introduction
