Your lovely family
Register button:
“
Register” detectors:
Press “register” button and stay for 2 seconds while the main console
is in “register” mode. The red LED indicator starts blinking. When the main console receives the
alarm signal from detector, it will bring out a long beep sound. Then the detector has been
successfully registered to the system.Press “register” button again, the LED indicator off and exit
to “register” mode.
“
Clear” detectors:
Press “register” button and stay for 2 seconds while the main console is in
“register” mode. The red LED indicator starts blinking. Then press again the button for 5 seconds.
When main console brings out one beep sound, the detector of registered data has been cleared.
Tenon:
Using any flat tool to press the tenon to open the upper cover.
AC power adaptor LED indicator: AC power is applied. When power on the unit, the green LED
indicator is on
。
Watning status LED indicator:
“Away warning” red LED indicator is on; “Home arming”
red LED indicator is blinking.
Back-up battery:
Back-up battery can be applied for power supply when power black-out.
Audio selection:
Buzzer/off /Music selection (Doorbell function).
DC adaptor:
insert hole of DC adaptor.
Spring to the register button:
Please make sure the spring has to be aligned to the tenon while
replacing the front cover back. The improper installation will result LED indicator switching on.
Volume adjustment :
Rotate and adjust volume level.
Speaker
：
Siren speaker.
Antenna socket:
Antenna socket.
Output connector :
NC
、
C
、
NO
、
+12V
、
GND
、
NO
、
C
、
NC
。
Controls and displays
NC/C/NO :
The dry contact status will change while power black-out.
+12V :
Auxiliary power (Note: voltage is 16V when no load; while it is about 12V when load current
is 600mA.)
GND :
Ground.
NO :
Normal open. When alarm is triggered, it will be activated after 8 seconds later. The dry
contact will change from NO to NC and will be back to NO after 15 seconds.
C :
NO/NC dry contact.
NC :
Normal close. When alarm is triggered, it will be activated after 8 seconds later. The dry
contact will change from NC to NO and will be back to NC after 15 seconds.
Output terminal connection
Wireless infrared detector are applied for motion detection and send signal to main console. Main
console will activate alarm and trigger related devices to prevent the intrusion. The effective detecting
distance can be up to 10m and the detecting angle is approximately 36 degree.
Wireless infrared Detector WS-001
1. “Away” arming mode: When system is setting as “Away” arming mode, it will have a 30-second
delay time to provide you enough time to exit the protected area before your system is armed. After
arming is done and detect any movement, it will be activated to main console in 15 seconds later.
2. “Home” arming mode: When system is set as “Home” arming mode, the main console will not
process alarm signal from IR detector.
Main console arming mode
1. Operation indicator
(LED indicator)
2. C / OFF / W
3. Sensitivity selection
4. Battery replacement
- When wireless infrared detector detects any movement, the red indicator
will be switched on for one second and then sends the signal to main
console.
- When low battery, the red indicator will be switched on for one second
and sends signal to main console.
C “Continuous”: Once the detector detects any movement, the next
detection will be activated in five seconds.
OFF “Switch off power”
W “Wait”: Once the detector detects any movement, the next detection
will be activated in 2~3 minutes.
- Three levels can be selected- Low/Medium/High.
- Open the battery compartment cover and insert 9V alkaline battery.
Buttons and accessories
8
7
1
1
1
2
3
4
5
6
7
8
9
10
11
12
