Your lovely family
System Alarm Diagram
When detector sends low battery signal, main console will bring out beep sound every 10 seconds, in
the meantime, please replace the battery of wireless motion detector.
Locations to avoid
Battery replacement
Please fix the antenna in (please refer to the figure 1) with Philips head screwdriver.
The main console can be mounted or can be fixed on the wall. Please refer the instructions
respectively as follows:
Wall-fixed
:
1.Please remove the front cover of main console by pressing downward with a pen tip or any flat tool.
2.Fix the unit on the wall with screws*2 in accessory kit. One of screw hole is in the upper left side
and the other is in the lower right side.
Wall-mounted :
1. Decide a proper location to install the main console and fix a screw on the wall.
2. Mount the main console by the fixed screw then.
System installation
Antenna installation
Main console installation
To ensure the normal operation to the detectors, please do not install the detectors in following
locations.
●
Location close to air conditioner, stove or heater. The sudden temperature change might
cause false alarm to the detector.
●
Avoid exposing under sunshine directly.
●
Locations close to big electronic equipment and high radio frequency.
●
Locations close to furniture, which might cause interruption to infrared ray from detector.
●
Locations close to pet’s door.
●
Locations close to any objects which might reflect infrared ray from detector.
●
Expose high humidity or location with extreme temperature fluctuation.
Wireless infrared detector installation
● The detector is recommended to be installed at a height of 1
∼
1.2m from the floor.
(The installation height can be adjusted upon installation site.)
● The effective detecting distance can be up to 10m and the detecting angle is approximately 36
degree.
4
3
Note: It is recommended to register the detectors before system installation. This will ensure
the normal operation of the whole system.
Note:Please make sure the tenon is right in the middle position while replacing the front
cover back. The improper installation will result LED indicator switching on.
Figure 1
11
