9
2
PU
SH
2
PU
SH
2
PU
SH
2
2
CHE
CK
BRU
SH
ON
/O
FF
CHECK
BRUSH
O
N
/O
F
F
The Brush Height Adjustment Button - Figures 13 & 14
The brush height adjustment button (9) has 4 brush height settings. Setting 1 is the
lowest brush setting and setting 4 is the highest brush setting. When starting the
vacuum, always start with the button set at 4, then lower button settings until the
brush reaches the proper height.
The brush height adjustment can be changed by foot or with the attachment tube.
To use the attachment tube, put the machine into the upright position, then lift the
tube from the machine. The end of the attachment tube (6) fits into the groove of
the brush height adjustment button (9).
The Check Brush Display - Figure 12
If the brush is jammed or overloaded, the machine will automatically switch off
and the orange indicator (43) will show on the Check Brush display (12). If this
occurs, unplug the machine and clear the obstruction.
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
41
42
1
38
16
6
Using the Attachment Tube, Hose & Attachments -
Figures 9, 10 & 11
The attachment tube (6) is useful for vacuuming corners and hard-to-reach areas.
The handle grip (1) should be in the upright, locked position
(as shown in figure
9)
. Grip the attachment tube handle (2), pull it up and away from the machine and
stretch out the hose (16) until it locks to the back of the tube (this locking action
will prevent the hose from retracting back into the attachment tube while it is in
use). Various attachments may be inserted onto the end of the tube. After use,
remove attachment and re-insert the attachment tube into the back of the
machine.
Be sure that the attachment tube handle (2) is inserted over the pro-
jection tab (see #33, page 7)
. If the attachment tube handle is properly seated
over the projection tab, the hose will automatically retract and you may resume
vacuuming. There is no need to turn off the vacuum while switching from upright
vacuuming to using the attachment tube or hose.
To use the hose without the attachment tube
(as shown in figure 10)
, pull the hose
out of the attachment tube while the tube is still attached to the machine and
secure-
ly seated over the projection tab (33).
Insert an attachment tool, if desired, onto the
end of the flexible hose. You may also release the hose while the attachment tube is
disengaged from the machine by pressing the hose release button (38) at the base of
the handle (2).
While using attachment tools, you may keep the brush roller off the carpet by
placing the handle (1) in its upright locked position and lowering the handle with
one hand to raise the brush roller off of the floor. Operate attachment accessories
with the other hand. Or, with the handle in the upright locked position, the
machine may be tipped backward so that it rests on the back side of the bag hous-
ing (21), and the power head is locked in a perpendicular position to the floor.
Ensure that no children or pets can come into contact with the spinning brush
roller.
To vacuum walls, under beds, or higher-reach areas, etc., the SEBO 300 and 350
vacuums can be fitted with an additional straight tube (41) and the Kombi nozzle
(42), the wall and floor brush or parquet brush (see optional attachments on page
6). The machine will then perform as a canister vacuum
(as shown in figure 11).
6
6
23
22
2
12
43
9
1
1
Figure 14
9
