10
MAINTENANCE
Figure 15
Figure 18
Figure 19
Figure 21
Always unplug vacuum from outlet before dismantling any part of the machine!
!
Dust Bag
Part# 5093AM
Electrostatic
Microfilter
Part# 5036ER
Exhaust Filter
Part# 50170ER
Brush Strip for SEBO 300
Part# 50415
Brush Strip for SEBO 350
Part# 2046
Changing the Dust Bag - Figures 15-17
When the “bag full” warning indicator (4 - figure 15) turns
orange, and there is not a clog, change the dust bag. To
remove the dust bag, push the cover release button (19 -
figure 16) and lift the cover (24) up to remove. Push the
lever over to the right (44 - figure 17). Squeeze the clamps
(45) on both sides of the dust bag sealing plate (46), slide
the plate from the holder and push the cap on to seal the
bag. Slide the sealing plate (46) of a new bag into the hold-
er and push it in until it locks into place. You may find it
convenient to store the bag cap inside the dust bag hous-
ing below the dust bag. Make sure the bag is tucked in at
the bottom. To replace the cover, insert the projections on
each side of the bottom of the cover into the correspon-
ding slots at the base of the housing. Close the cover
ensuring that the cover “clicks” shut.
Changing the Micro-Hygiene Filter
Figure 18
The micro-hygiene filter needs to be changed when it
becomes extremely dirty or clogged with dust, or after
approximately 20 dust bags have been used. To change
the micro-hygiene filter, remove the dust bag housing
cover (24) by pushing the cover release button (19 - figure
16) and lifting the cover up and out. Grasp the loop (47 -
figure 18) at the bottom of the filter and slide the filter
out. To replace, lift the metal bar (48 - figure 18 inset) and
slide the new filter in using the tracks as guides. Replace
the cover and snap it in place.
Changing the Exhaust Filter
Figures 19 & 20
After 20 bags have been used, change the exhaust filter.
To change the exhaust filter, remove the dust bag hous-
ing cover (24) by pressing the cover release button (19)
and lifting the cover up and out. Grasp the handle on the
orange filter holder (49 - figure 19) and pull it out. Pull
the filter out of the holder. Insert the new filter rubber-
gasket-side-down (50 - figure 20) into the holder and re-
insert the holder. Replace the dust bag housing cover and
snap it in place.
Changing the Brush Strip - Figures 21-23
To replace the brush strip, push the brush release button
(10), remove the side plate (51 - figure 21), turn the brush
roller until the end of the brush strip can be accessed at
the notch (52 - figure 22). Grasp the brush strip (53) from
the underside of the power head and push it out through
the notch far enough to be grasped and pulled out. Insert
the new brush strip and press the side plate (51) back into
place, making sure that the plate is firmly seated.
Figure 20
Figure 16
4
19
47
48
49
50
49
Figure 22
Figure 23
10
51
52
53
24
Figure 17
44
46
45
45
