I
MPORTANT
FOR
THE
INSTALLER
-
The device must never be used by children or persons with
reduced physical-psychological abilities, unless supervised or
trained on the functioning and the use modalities.
- Do not allow children to play with the device.
- ATTENTION: keep this instruction manual and respect the
important safety prescriptions contained herein. The non com-
pliance with the prescriptions may cause damages and seri-
ous accidents.
- Frequently examine the plant to detect any signs of dam-
aging. Do not use the device if a repair intervention is neces-
sary.
Attention
All operations which require the opening of the casing (cables
connection, programming, etc.) must be carried out by expert
personnel during installation. For any further operation which
requires the casing to be re-opened (re-programming, repair or
installation amendments) contact the after-sales assistance.
STATEUROP
declares that the products:
WiWeather 443 - 868
are in compliance with the specifics of R&TTE
99/5/EC, EMC 2004/108/EC, LVD 2006/95/EC Directives
.
3
Rev. 1.0 20/02/09
I
MPORTANT
FOR
THE
INSTALLER
-
The device must be permanently connected to the power
supply network and not have any type of sectioning device of
the 230Vac electric line, it will therefore be under the care of
the installer, to provide the plant with a sectioning device. It is
necessary to install a single-phase switch with over-voltage
category III. It must be positioned so as to be protected
against accidental closures.
- For connections (power supply), use flexible cables under in-
sulating sheath in harmonised polychloroprene (H05RN-F)
with minimum section of the conductors equal to 0.75 mm
2
- The connection cables must be fixed by assembling cable
clamps supplied with the product.
- The device, at the time of installing, must be carefully man-
aged, ensuring to have assembled
the composing parts correctly. Pay particular attention to
the ceramic plate and to the connecting flat. When re-closing
the box, the latter must fold, on itself, in an orderly manner.
- It is very important to establish the exact location so that
the product is exposed to the same atmospheric agents as
when it is controlled.
- Ensure that the device remains inclined at about 45 de-
grees (fixing area at top, round extremity of the box at bot-
tom).
- Do not paint or varnish the sensitive surface of the control
unit.
- The dirt which builds up on the rain sensor surface limits
the sensitivity: it is therefore recommended to clean it once or
twice a year with a damp cloth, after having disconnected the
automation.
−
For a correct functioning, it is recommended to always use
only one device for one or more control units installed in an
action range of 20 meters.
−
Always carry out the tests of the sensors to ensure the cor-
rect functioning of the installed system.
