F
OR
THE
I
NSTALLER
-
IMPORTANT
−
Before gate automation, it is necessary to check the
good condition of the gate and its compliance with EN
12604 with respect to directive on machines.
−
The control unit is not equipped with 230 Vac electric
line sectioning device. The installer is responsible for
installing a sectioning device in the system. The
sectioning device must be protected against accidental
closing in compliance with 5.2.9 section of EN 12453.
−
Wiring of external electrical components must comply
with EN 60204-1 as amended in section 5.2.7 of EN
12453. The fixing of power supply leads and connection
cables must be secured through the use of cable
clamps supplied on demand.
−
If present, the push-button station for manual control
must be mounted in such a way that the user is not in a
dangerous position.
−
The motor reducer used to move the gate must comply
with section 5.2.7. of EN 12453.
−
The D.S. Power Supply output must be dedicated to
photoelectric cell power supply. It must not be used for
other applications.
−
The control unit tests the operation of photoelectric cells
at every manoeuvring cycle to guarantee protection
against failures of anti-compression devices of
Category 2 in compliance with section 5.1.1.6 of EN
12453. Therefore, it safety devices are not connected
and/or operated, the control unit is not enabled for
operation.
−
The safety function guaranteed by the control unit is only
active during closing; therefore protection during
opening must be guaranteed during installation with
measurements (shelters or safety distances) that are
independent from the control circuit.
−
For the correct operation of the radio receiver, if two or
more control units are used, we recommend you to
install the devices at least 3 metres away from each
other.
SEAV s.r.l.
hereby declares that the products below:
Electronic Control Unit:
LG 2186 - LRS 2186 - LRS 2186 SET - LRH 2186
complies with requirements of Directives R&TTE 99/5/EC,
EMC 2004/108/EC, LVD 2006/95/EC.
Rel. 1.1 of 12-03-07
