18
SW2 SW2
LP=OFF
LP=ON
INHIBITOR INPUT FUNCTIONING MODE
RTX 2252 (Sensor) device enables connection of an (NC) contact for the temporary inhibit-
ing of the sensitive edge it is connected to.
ATTENTION:
If not used the inhibitor must always be jumped.
DISCHARGED BATTERY SIGNAL
The RTX 2252 (Sensor) device signals the discharged battery state through quick flashing
of the TX LED. The same information is also sent to RTX 2251 (Base) device, that signals
the event with visual and acoustic warnings.
ATTENTION:
We recommend immediately replacing the device batteries if TX LED
flashes.
RESET:
To reset the factory configuration, press and hold the SET key for more than 2 seconds
until the TX LED flashes 3 times.
attention
:
- For excellent functioning, annually replace
the 1.5V alkaline batteries.
- To change batteries open by the means of
a screwdriver the case of the Sensor.
- Dispose of the used batteries in appropri-
ate containers.
Rev. 3.0 05/09/2016
