Seat TOUCH/COLOUR, Руководство пользователя

Страница: 8 / 44

Introduction
Setting knob : The function of this knob
depends on the mode that is currently ac-
tive.
CD slot*
›››
page 18 .
Memory card slot
.
General operating information
Introduction
Note
●
Lightly pressing the buttons or briefly
pressing the touchscreen is sufficient to op-
erate the unit.
●
It is possible that not all the functions and
function buttons are available as the software
of the unit responds to the specific character-
istics of each market. A missing function but-
ton on the screen is not the result of an error
in the unit.
● Due to country-specific legislation, certain
functions cannot be selected on the screen
when the vehicle is travelling above a certain
speed.
● Using a mobile phone inside the vehicle
can cause noise in the speakers.
● There may be restrictions on the use of
Bluetooth devices in some countries. Infor-
mation is available from the local authorities.
● In some vehicles equipped with a parking
distance warning system, the volume of the
4
5
6
audio source is automatically lowered when
the gear is engaged.
● If the steering wheel has a voice control
button

, it will not work in this radio mod-
el, so it has no function in relation to the ra-
dio.
Rotary knobs and buttons
Rotary knobs
The left rotary knob
›››
Fig. 1
1
is is used as
the volume control

or the on/off button.
The right-hand rotary knob
›››
Fig. 1
4
is
used as the setting knob.
Infotainment buttons
In these instructions, the unit buttons are de-
picted by the word “infotainment button”
and their function is shown inside a rectan-
gle (for example:
MEDIA
infotainment button
›››
Fig. 1 .
The infotainment buttons are operated by
pressing them or holding them down.
Switching on and off
To switch the unit on or off manually, briefly
press the rotary knob

›››
Fig. 1
1
.
When the unit is switched on the system
starts up. The last active audio source will be
played with the volume set, as long this does
not exceed the maximum, predefined switch-
on volume
›››
page 37 .
The unit will switch off automatically when
the vehicle key is removed. If you turn the
unit back on after the engine has been
switched off, it will turn off automatically af-
ter approximately 30 minutes (delayed
switch-off).
Note
●
The unit is linked to the vehicle. It cannot
be used in any other vehicle.
● If only the battery has been disconnected
from the vehicle, the vehicle must be started
before turning the unit back on.
Adjusting the base volume
Function Action
Increase
the vol-
ume. Turn the volume control

clockwise or
scroll the

thumbwheel upwards on the
multifunction steering wheel
›››
Book-
let Instruction Manual .
Lower the
volume. Turn the volume control

anticlockwise
or scroll the thumbwheel downwards

on the multifunction steering wheel.
6