8
Introduction
General information on operating the unit
Introduction
Note
●
Lightly pressing the buttons or briefly pressing the touchscreen is suffi-
cient to operate the unit.
●
It is possible that not all the functions and function buttons are availa-
ble as the software of the unit responds to the specific characteristics of
each market. If a function button is missing on the display this is not due to
an error in the unit.
●
Due to country-specific legislation, certain functions cannot be selected
on the screen when the vehicle is travelling above a certain speed.
●
Using a mobile phone inside the vehicle can cause noise in the speak-
ers.
●
There may be restrictions on the use of Bluetooth devices in some coun-
tries. Information is available from the local authorities.
●
In some vehicles equipped with a parking distance warning system, the
volume of the audio source is automatically lowered when the gear is en-
gaged.
Rotary push knobs and buttons
Rotary/push knob
The left rotary push knob
⇒
is referred to as the volume control
or the on/off button.
The right rotary push knob
⇒
Fig. 1
4
is referred to as the setting button.
Infotainment buttons
The unit buttons are represented in this manual with the word “infotain-
ment button” and their function is shown inside a rectangle (for example:
MEDIA
infotainment button
⇒
Fig. 1
.
The infotainment buttons are operated by pressing them or holding them
down.
Switching on and off
To switch the unit on or off manually, briefly press the rotary push knob
⇒
Fig. 1
1
.
When you connect the system it will play at the volume at which it was last
set, provided it does not exceed the maximum permitted volume
⇒
page 64.
The unit will switch off automatically when the vehicle key is removed. If you
turn the unit back on after the engine has been switched off, it will turn off
automatically after approximately 30 minutes (delayed switch-off).
Note
●
The unit is linked to the vehicle. It cannot be used in any other vehicle.
●
When the vehicle battery is disconnected, you must turn ignition on be-
fore switching the unit on again.
