Seat Leon 2013, Руководство по ремонту

Страница: 261 / 279

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Installation position of rear clamp
– Fit clamp in position shown.
• Permissible installation angle -α- = approx. 20°
• Bolt connections face to rear.
• Nuts facing upwards
1.1.2 Assembly overview: silencer, Leon ST
1 - Front silencer
❑ Combined in one unit
with rear silencer as
original equipment. Can
be renewed individually
for repair purposes
❑ Removing and installing
⇒ page 259
❑ Disconnecting exhaust
pipes/silencers
⇒ page 257
❑ Aligning exhaust sys‐
tem free of stress
⇒ page 261 .
2 - Holder
❑ Replace if damaged
3 - Mounting »A«
❑ Replace if damaged
❑ Aligning
⇒ page 256
4 - Bolt
❑ M8 x 25
❑ 20 Nm
5 - Nut
❑ 30 Nm
6 - Clamp (rear)
❑ Align exhaust system so
it is free of stress before
tightening clamp
⇒ page 261
❑ Installation position
⇒ page 257
❑ Tighten bolted connec‐
tions evenly
7 - Mounting »B«
❑ Replace if damaged
❑ Aligning
⇒ page 256
8 - Bolt
❑ M8 x 25
❑ 20 Nm
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
1. Exhaust pipes/silencers
255