© 2003 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
Fax: 604.270.7172
Web:
www.seastarsolutions.com
INSTALLATION INSTRUCTIONS
Copy Par t# 764607, Rev. E, 08/2013
Page 1 of 2
Figure A.
WARNING
Determine desired mounting position of the BayStar Plus Helm
pump. Ensure that the steering wheel will not inter fere with any
other functional equipment. Check for adequate space behind
the dash. The BayStar Plus Helm Pump can be installed with the
shaft in the horizontal, ver tical or any angle in between. The filler
plug must always be in the uppermost position.
Mounting the Helm
Drilling the Hole
Using the mounting plate on page 2, use the following steps
tomake an accurate and clean cut into the dash.
1.
Tape the template to the dash and use a center punch for
locating the holes on dash, or photocopy if required to use as
a drilling template.
If a photocopy is required check ALL
MEASUREMENTS as per the template to ensure that the
photocopied template is true and correct.
2.
Before drilling the holes, check that the helm location will
allow unrestricted movement of the steering wheel.
3.
Drill the 3" diameter center hole and the four 5/16" diameter
mounting holes, positioned as shown.
Cleaning fluids containing ammonia, acids or any other corrosive
ingredients MUST NOT be used for cleaning any part of this
Hydraulic Steering System. Failure to comply will cause serious
damage to the steering system, resulting in possible loss of
steering, causing property damage, personal injury and/or death.
3" DIA.
(76 mm)
FILLER PORT
3/4" STANDARD TAPER
1/4" NPT PORTS (4)
1/4" NC STUDS(4)
3-15/16"
(100 mm)
1-15/16"
(50 mm)
2-5/8"
(67 mm)
6-1/16" (155 mm)
4-7/16"
(113 mm)
2-5/8"
(67 mm)
HELM PUMP # HH4514
