3. Connection and installation of the
MobilGate-128d
The connection points of the interface can be found in the figure below:
Up: Antenna
USB connector
Down: Relay outputs
Input connectors
Power supply connector
The power connection needs 10-30V DC supply
voltage. The inputs of the
MobilGate-128d
GSM gate
controller can be triggered by voltage-less contact on
the simple inputs. The numbering of the module inputs
is marked on the board of printed circuit. It has high
current No-Com type relay outputs and their max load
is 48V and 1A. The No and Com points of the relays
are wired out. The GSM modem has a screwed SMA
aerial connector and a small-sized straight pole aerial
or an aerial with a coax cable or similar plug can also be installed to it. The power input of the GSM
gate opener module is protected against reverse polarity and it is equipped with 500mA multifuse.
The input voltage on the general purpose inputs ranges is from 5V ... 30Vdc.
4.
Configuring MobilGate-128d using a computer:
MobilGate-128d
can be configured with computer or notebook via USB-port by using our
free software. A SIM card that is able to send SMS and it is not protected with PIN code has to be
isrequired for Windows XP or any newer operation system. After driver installation, the next step is
inserted into the module. When the device is connected to the USB-port, the module driver has to be
SeaSoft Ltd.
www.seasoft.hu - www.mobil-control.eu T: (+36) 62 406405 M: (+36) 30 2557688 F: (+36) 62 405-969
