it stopped. The module checks the
GSM modem regularly and turns it
off in case of network or signal
problems,
then
turns
it
back,
connects to the network again,
restoring itself into operating state.
The
Mobilgate-128c
GSM gate
control module can be purchased in
a
package
with
downloader
software and aerial. The panel
version is called
MobilGate-128
, its
enclosure
version
is
called
MobilGate-128d
and the version
that can be installed to a C-rail
(DIN-rail) with opto-isolated inputs
and with 4 pcs of high current relays
is called
MobilGate-128c
.
It can be equipped either with
smaller, rectangular dual-band stick
antenna or with magnetic, screwable
external
antenna
equipped
with
RG174 SMA-connector.
2. LED diode signals
LED diodes can be found on the side of the panel in order to indicate possible error messages
in the following order:
Red "On" LED
Continuously:
The interface is operational. It has to remain lit after turning it on.
White "GSM" LED
Blinking
GSM module operational status. It has to light up after around 25 seconds then flash
according to its functioning. Its flashing indicated that the device is connected to the
network.
Green "Heartbit" LED
Blinking
It is the life signal of the device. When the device is turned on, it does not blink until
the device is connected to the network. It starts blinking after the device is connected
to netork. The number of flashes (0 to 10) indicates the signal strength. 0 flash means
the device is not connected to network, 2 or 3 flashes mean low-signal and it occurs
when GSM connection is not secure. 4 or more flashes mean sufficient signal
strength for operation. In the case the green LED doesn’t light up after 1 minute, the
modem could not connect to the network at all. The aerial and the SIM card have to
be checked, e.g. the SIM card is protected with SIM PIN.
SeaSoft Ltd.
www.seasoft.hu - www.mobil-control.eu T: (+36) 62 406405 M: (+36) 30 2557688 F: (+36) 62 405-969
