18
MAINTENANCE
FIG. 15
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause
the battery to “leak” power.
• Remove terminal guard.
• Disconnect BLACK battery cable fi rst then RED bat-
tery cable and remove battery from tractor.
• Rinse the battery with plain water and dry.
• Clean terminals and battery cable ends with wire brush
until bright.
• Coat terminals with grease or petroleum jelly.
• Reinstall battery (See “CONNECT BATTERY” in the
Assembly sec tion of this manual).
V-BELTS
Check V-belts for deterioration and wear after 100 hours
of operation and replace if necessary. The belts are not
ad just able. Re place belts if they begin to slip from wear.
TRANSAXLE COOLING
The transmission fan and cooling fi ns should be kept clean
to assure proper cooling.
Do not attempt to clean fan or transmission while engine
is running or while the transmission is hot. To prevent pos-
si ble damage to seals, do not use high pressure water or
steam to clean transaxle.
• Inspect cooling fan to be sure fan blades are intact and
clean.
• Inspect cooling fi ns for dirt, grass clippings and other
materials. To prevent damage to seals, do not use
compressed air or high pressure sprayer to clean cool-
ing fi ns.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fl uid main te -
nance is not required for the life of the transaxle. Should
the transaxle ever leak or require servicing, contact your
near est au tho rized ser vice center/department.
TO CHANGE ENGINE OIL (See Fig. 15)
Determine temperature range expected before oil change.
All oil must meet API service classifi cation SF-SJ.
• Be sure tractor is on level surface.
• Oil will drain more freely when warm.
• Catch oil in a suitable container.
• Remove oil fi ll cap/dipstick. Be careful not to allow dirt
to enter the engine when changing oil.
• Remove yellow cap from end of drain valve and install
the drain tube onto the fi tting.
02
463
CLOSED
AND
LOCKED
POSITION
YEL LOW
CAP
DRAIN
TUBE
OIL DRAIN VALVE
• Unlock drain valve by pushing inward and turning
coun ter clock wise.
• To open, pull out on the drain valve.
• After oil has drained completely, close and lock the
drain valve by pushing inward and turning clockwise
until the pin is in the locked position as shown.
• Remove the drain tube and replace the cap onto to the
bottom fi tting of the drain valve.
• Refi ll engine with oil through oil fi ll dipstick tube. Pour slowly.
Do not overfi ll. For approximate capacity see “PRODUCT
SPECIFICATIONS” section of this man u al.
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service
classifi cation SF-SJ. Select the oil’s SAE viscosity grade
according to your expected operating temperature. When
operating in temperatures below 0º F (-18º C) syn thet ic
oil must be used.
* CAUTION:
Air cooled engines run hotter than automo-
tive engines. The use of non-synthetic multi-viscosity oils
(5W30, 10W30 etc.) in temperatures above 40º F (4º C) will
result in higher than normal oil consumption. When using a
multi-viscosity oil, check oil level more frequently.
** CAUTION:
SAE 30 oil, if used below 40º F (4º C), will
result in hard starting and possible engine bore damage
due to inadequate lubrication.
NOTE:
Synthetic oil meeting ILSAC GF-2, API
certifi cation mark and API service symbol (shown
at left) with "SJ/CF ENERGY CONSERVING" or
higher, is an acceptable oil at all temperatures.
Use of synthetic oil does not alter required
oil change intervals.
Change the oil after every 50 hours of operation or at least
once a year if the tractor is not used for 50 hours in one
year.
Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation. Tighten oil fi ll
cap/dipstick securely each time you check the oil level.
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
SAE VISCOSITY GRADES
-20
-20
-10
10
-30
20
20
30
40
0
0
40
80
100
F
C
*
32
60
**
30
Synthetic 5W-30, 10W-30
5W-30, 10W-30
oil_visc_chart9_e.
CER
TIFIED
A
M
E
R
IC
AN
PET
OLEUM
IN
ST
IT
U
TE
AP
I S
ERVICE SJ/C
F
E
N
ER
GY CONSER
VI
N
G
SAE
5W-30
FOR
GASOLINE
ENGINES
Содержание CRAFTSMAN 944.604001
Страница 46: ...46 REPAIR PARTS TRACTOR MODEL NUMBER 944 604001 HYDRO GEAR TRANSAXLE MODEL NUMBER 336 0510 ...
Страница 53: ...53 SERVICE NOTES ...
Страница 54: ...54 SERVICE NOTES ...
Страница 56: ...Printed in U S A 191960 03 09 04 TR 02488 ...