5
Hazardous fumes. Follow cement manu-
facturer’s instructions. Use PVC cement only in a well
ventilated place away from fire or flame.
11. Put clamp on adapter; leave loose. Mount check valve
in adapter; thread assembly into tee.
12. Slip pump into check valve. Tighten clamp.
13. Make sure battery is fully charged; then check opera-
tion by disconnecting power to primary sump pump
and filling sump until Backup Sump Pump starts. Run
Backup Pump through one complete cycle.
ELECTRICAL CONNECTIONS
Hazardous voltage. Can cause serious or
fatal electrical shock. Review safety instructions, Page 2,
before operating charger.
If your outlet is not grounded, install a copper wire (at
least 14 gauge) from the outlet box to a cold water pipe.
Use ground clamp on pipe. BE SURE that the cold water
pipe used has metal continuity to electrical ground.
Battery charger is double insulated. DO NOT modify cord
or plug.
CHARGER/BATTERY INSTALLATION
NOTICE: Alarm will sound when charger is first
connected to battery. Press ALARM TEST/RESET button on
charger. If alarm continues to sound, disconnect one
charger lead from the battery and reconnect it. Press
ALARM TEST/RESET again; alarm will stop sounding.
1. Connect charger as shown in Figure 3.
A. Connect Positive (+) lead from charger to positive
battery post.
B. Connect Negative (–) lead from charger to negative
battery post.
C. Third lead from charger is factory connected to
lead from pump motor/float switch.
NOTICE: If charger is connected backwards, pump
will not operate properly, battery will not charge.
2. Plug in power cord to a 115-125 Volt AC outlet deliv-
ering at least 2 amps. Do not use a switch controlled
outlet. Mark circuit in main power panel “Backup
sump pump power supply; do not turn off”.
3. With charger properly connected and plugged in, the
panel on the front of the charger will appear as in one
of the following:
A. If battery is dead, charger will supply about 10
amps power (see Figure 4A).
B. If battery is near full charge, charger will deliver
about 5 amps power (see Figure 4B).
D C A M P S
CHARGED
CHARGING
2 4 6 8 1 0 1 2
C H A R G E C O M P L E T E
CHARGED
CHARGING
D C A M P S
2 4 6 8 1 0 1 2
C H A R G E C O M P L E T E
1413 1194
D C A M P S
CHARGED
CHARGING
2 4 6 8 1 0 1 2
C H A R G E C O M P L E T E
CHARGED
CHARGING
2 4 6 8 1 0 1 2
C H A R G E C O M P L E T E
Figure 4 – Battery Backup Control Panel
A. Battery depleted - charging current 10 amps.
B. Battery nearly charged - current about 5 amps.
C. Charge complete - current 0 amps, LED lights
up.
Reducer Bushing (2 Supplied)
1-1/2x1-1/2x1-1/4
Tee - PVC
Pipe
Adapter
Hose Clamp
Check
Valve
Main Pump Discharge Pipe
Check Valve to Prevent
Recirculation into Sump
1464 0195
Figure 2B – Installation Diagram
White
Black
Negative
(Black)
Positive
Battery Clamp
Negative
Battery Clamp
Brown
Sensor
Sensor
Black
Positive
(Black w/
Red Tracer)
Fuse
Holder
1411 1194
–
+
–
+
+
Backup
Pump
Figure 3 – Wiring Connections
A.
B.
C.
