3
CONTENTS
Safety..................................................................................2
Warranty/Introduction .......................................................3
Installation.......................................................................4-8
Electrical........................................................................9-10
Operation .........................................................................11
Maintenance.....................................................................11
Service .........................................................................12-13
Troubleshooting ..........................................................14-15
Pump Performance ..........................................................15
Repair Parts .................................................................16-19
INTRODUCTION
We suggest you take a few minutes to read the instructions
contained in this manual before installing and using your
pump. This will help you obtain the full benefits of the qual-
ity and convenience built into this equipment. It will also
help you avoid any needless service expense resulting from
causes beyond our control which naturally cannot be cov-
ered in our warranty.
1. Read the Owners Manual and Rules for Safe Operation
and Installation Instructions carefully. Failure to follow
these Rules and Instructions could cause serious bodily
injury, and/or property damage.
2. Check your local electrical wiring codes before installa-
tion. If your local codes are not followed, your pump will
not work to its full rated capacity. If in doubt, contact
your local Power Company.
3. Be certain your pump installation meets all local plumb-
ing, pump and well codes.
4. While installing the pump, always keep the well covered
to prevent leaves and foreign matter from falling into the
well and contaminating the water and/or causing possi-
ble serious damage to the mechanical operation of the
pump.
5. Always test the well water for purity before using. Check
with local health department for testing procedure.
6. Before installing or servicing your pump, BE CERTAIN
pump power source is disconnected.
7. Be sure your pump electrical circuit is properly grounded.
8. Complete pump and piping system MUST be protected
against below freezing temperature. Failure to do so could
cause severe damage and voids the Warranty.
9. Make sure the line voltage and frequency of the electrical
circuit supply agree with the motor wiring. If motor is
dual voltage type, BE SURE it is wired correctly for your
power supply.
10. The correct fusing and wiring sizing is essential to proper
motor operation. Recommended fusing and wire size data
is in the manual.
THREE YEAR LIMITED WARRANTY
Provided that it is installed and operated according to the owner’s manual instructions, if this pump fails due to a
defect in material or workmanship within one year from the date of purchase, it will be repaired or replaced free
of charge.
During the second year and third year from purchase date, a free pump part will be supplied for a defective one.
You must pay the labor cost if you wish to have it installed.
Warranty service is available by returning this product to place of purchase for replacement, or by calling
1-800-4-MY-HOME
®
to arrange for part replacement or product repair.
This warranty is VOID if this pump is used for commercial or rental purposes.
Sears is not liable for loss or damage to property, nor for any incidental or consequential loss or expense from
property damage, that results directly or indirectly from the use of this product.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears Roebuck and Co., Dept. 817WA, Hoffman Estates, IL 60179
RULES FOR SAFE INSTALLATION AND OPERATION
