4
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
2.
In the circuit breaker, fuse box or junction box: connect
appliance and power supply cable wires as shown on
figure 3.
Where local codes DO NOT permit connecting the
appliance-grounding conductor to the neutral (white) wire,
or if connecting to 4-wire electrical system (see figure 4):
1.
Disconnect the power supply.
2.
Separate the green (or bare copper) and whiteappliance
cable wires.
3.
Cap the white wire from the power supply cable if a3-wire
appliance cable is supplied.
4.
In the circuit breaker, fuse box or junction box: connect
appliance and power supply cable wires as shown on figure
4.
Improper connection of aluminum house
wiring to copper leads can result in a short
circuit or fire. Use only connectors designed for joining
copper to aluminum, and follow the connector manufacturer
recommended procedure closely.
DO NOT ground to a gas supply pipe. DO
NOT connect to electrical power supply
until appliance is permanently grounded. Connect the
ground wire before turning on the power.
Cooktop Installation
These cooktops are designed to fit various cutout sizes.
The minimum and maximum cutout openings are shown
in Figure 1.
Secure the Unit
Unit Clamp Down Information
Once the cooktop is installed and centered in the
counter opening, you must clamp the unit down as
shown.
To clamp down, insert the offset side of the angle bracket
into the slots on each side of the unit. Then run the
thumb screw through the bracket, up against the bottom
of the counter. Tighten until the unit draws down (figure
5).
Checking Operation
Refer to the
Use and Care Guide
for operation.
Do not touch cooktop glass or elements.
They may be hot enough to burn you.
WARNING
WARNING
CAUTION
Wires
Wires
listed)
Wires
Wires
listed)
