9
ASSEMBLY STEP 4
Install Chain//cable &
Attach Sprocket Cover
Detach cable loop from carton and fasten to trolley
with a master link from coin envelope.
MASTER LINK PROCEDURE: Push pins of master
link bar through cable loop and hole in front end of
trolley (See Figure A,) Push cap over pins and into
notches until both pins are securely locked.
Caution: Keep the chain and cable taut during
installation to help prevent kinking..
C
AUTION: DO NOT REMOVE THE CHAIN/CABLE
FROM THE DISPENSER CARTON
With trolley against screwdriver, dispense cable
around pulley. Proceed back around opener sprocket
as shown in Figure B (be sure sprocket teeth engage
chain) and forward to threaded trolley shaft (See
Figure C.)
Use second master link to connect chain to flat end of
shaft. Check to make sure the chain is not
twisted.
REMOVE THE SCREWDRIVER.
ATTACH SPROCKET COVER TO OPENER: Insert
back tab in opener slot. Bend cover forward and insert
front tab in slot on mounting plate.
TIGHTEN CHAIN/CABLE
CAUTION: Keep the chain from twisting as nuts
are turned.
Thread inner nut on the trolley in the direction shown.
(loosen outer nut first if necessary.)
Tension is correct when chain is approximately 1/2"
above base of Tee rail. midway between cable pulley
bracket and opener. To maintain proper tension,
tighten outer nut as shown.
Sprocket noise can result if chain is either too
loose or too tight.
CAUTION: Do not overtighten chain. (See Page 6).
Cable
Pulley
Cable
Loop
Master
Link
Master Link
Clip-On Spring
Trolley
T-Rail
Pin
Pin Notch
Chain
Flat End of
Threaded Shaft
Master
Link Cap
Master
Link Cap
Master Link
Clip-On Spring
Install Chain and Cable
In This Direction
C
A
Sprocket
Cover
Mounting
Plate
Tab Slot
B
Opener Chassis
Sprocket
Install Chain
In This Direction
Tighten
Outer
Nut
Trolley
Chain
Base of Tee Rail
Tighten
Inner
Nut
Lock
Washer
1/2 Inch
