SeaPerch Remotely Operated Vehicle, Руководство по монтажу

Страница: 49 / 110

OPTIONAL PROCEDURE 2.3
– ALTERNATE MOTOR 1
SeaPerch ROV Construction Manual
– Version 2010-04NW
2.3-3
Figure 2.3-4: Final Tape Wrapping Process for the Motors
4. Wrap a longer piece of tape around the sides of the motor. Start at one end
with the edge of the tape extending about 1/16” (~2 mm) past the end of the
motor, so that it can be folded down to form a good seal.
Tape only a single
layer around the motor,
overlapping each piece only about 1/8” (3 mm) at its
ends. Cut about six small slits around the curved edge of the tape that
extends past the end of the motor, to aid in folding it down without wrinkles.
Then fold it over the end as smoothly as possible. Figure 2.3-4 shows the
final taping process for both ends of the motor.
5. Similarly, at the other end of the motor, place the edge of the tape to about
1/16” (~2 mm) past the end, wrap it around the motor, overlapping slightly as
before, and then use about six small cuts around the curved edge to help
make a tight seal when you fold the tape over that end.
6. Repeat Steps 3 through 5 for the other two motors.
7. Make sure that ALL holes in the motors are sealed well by pressing, rubbing,
and squeezing the tape with your fingers over the entire surface of each
motor shell.
Procedure 2.3 – Continued