Seamax PowerMax Series, Руководство пользователя

Страница: 11 / 12

11
4.
TROUBLE SHOOTING
During the usage of the electric outboard motor, the propeller is possible to get stuck by weeds, fishing lines or
fishing webs. Sometimes due to the variance of the water depth, the propeller is covered by the silt. If any of those
situations stated above happens, please disconnect the battery in time and clean up the propeller. (Please DO NOT
rise steps and increase the thrust of electric outboard motor to solve the problem, it may cause permanent damages
to the electric outboard motor.)
OPERATION ERROR INDICATION
The motor has an operation indicator function, and it will automatically stop if the following error occurs.
 Power indicator is off. The motor does not work. Check and make sure the power cable is well connected.

All power level lights are off. Only red light is on. Motor does not work. Check the battery voltage.
 Motor internal voltage protection is on. Motor does not work. Check the battery voltage.
 The speed control handle is not at the Neutral position. Turn it to the Neutral, and a “beep” will sound.

A running motor suddenly stops at the current speed. Return the speed control handle to its Neutral position
and start again.
 A running motor frequently stops. Check the propeller to make sure no fishing line or weeds blocking it.
Otherwise, it may trigger the high current protection mode.
AUDIO PATTERN
AUDIO CONDITION
3 beep sound System ready, motor stand by
Continuous short beep High voltage protection triggered. Low voltage protection triggered. System ready
but speed control handle is not at Netural
Continous quick short beep Motor running with high Amp current condition
Continuous long beep Motor stops, and waits for speed control handle back to Netural.
LACK OF POWER

Propeller may be fouled. Remove, clean and replace the propeller.
 Battery connections may be corroded.
 Battery has low voltage. Check and recharge it.

Battery may be faulty. Check and recharge it.
 Bad or faulty connection in boat wiring or electric motor wiring
 Permanent magnet cracked or chipped. Motor will whine or grind.
HARD TO STEERING

Check if the steering tension screw is loosened.
 Clean the motor shaft and apply lubricant to the fasteners and turning parts.

Make sure the underwater unit is in good condition, and not blocked by any obstacles.