> Installation
A step by step assistance
1.
Before any operation, turn off the
~
12V power
supply from the safety isolating transformer.
2.
Screw the SeaMAID adapter (3) at the back of the
wall inlet (2), diameter 50mm
3.
Screw the SeaMAID adapter (6) at the back of the
junction box (7). (thread ¾’’)
4.
Glue the PVC conduit (4) at the back of adapters 3
and 6.
5.
Pass the cable (5) through the inlet fitting, to the
junction box and tight it up. (a grommet can be
useful).
6.
Unscrew the 3 screws (8) of the projector front
cover (1) and take it off.
7.
Screw the projector(1) by hand into the vacuum
fitting (2)till complete blockage
8.
Replace the front cover by screwing the 3 screws
in the U shaped support.
9.
Check the cover stays free of movement with
hand action
10.
Connect the cable to the
~
12V power supply in
the junction box using waterproof connectors
11.
Wrap the remaining cable into the junction box
and close it. (This operation allows an easy
projector disassembly in case of replacement
)
12. Switch the
~
12V power on, the projector lights
Caution: use the black gasket with the size adapted to the vacuum fitting to maintain the
projector position after screwing
