Latest products and information available at www.sealite.com
8
BargeSafe™ Solar 3nm LED Barge Light
COLREG-72 & UL 1104 Certified
Testing the BargeSafe™ Solar 3nm Light
1. Turn the BargeSafe™ Solar 3nm on by flicking the switch on the lid.
The light will automatically activate for 30 seconds. If the BargeSafe™ Solar 3nm is in daylight, it will
automatically turn off.
2. Place the light in darkness for approximately 1 minute.
E.g. a dark room or cover over the light with
a dark jacket. The BargeSafe™ Solar 3nm needs to see 30 seconds of continuous darkness before
it will activate.
3. If the light does not activate within this time, check the following.
• Is the light is turned on?
• Is the battery correctly installed?
• Is it dark enough?
Low Battery Status
The BargeSafe™ Solar 3nm will run for many nights on a single 12v 12Ah SLA Battery, as a number
of battery brands may be used in this unit, the number of nights the BargeSafe™ Solar 3nm will
operate for will vary.
The BargeSafe™ Solar 3nm will start to flash once every 10 seconds when the battery voltage drops
below 10.5V
The BargeSafe™ Solar 3nm will stop operating when the battery drops below 10.5V.
