Sealife SL400, Инструкция по эксплуатации

Страница: 16 / 52

15
7. If your phone has a protective case, it is recommended to remove it. Insert the phone into housing to
check the fit. Push the phone up against the bow-shaped spring until the bottom of the phone can be
pushed down and held by the rubber grip tabs. Then, slide the phone left as far as possible. Over a soft
surface, like a towel, check that the phone is securely held in position and that no grip tabs touch buttons
on the side of the phone. Remove the phone by pushing up on the bow spring and lifting the phone up.
iPhone 7 with large rubber grip tabs installed iPhone 8 Plus with small rubber grip tabs installed
Note
•
Some phones with protective case may be small enough to securely fit inside the housing without
removing the protective case. In that case, you may try leaving on the protective case.
•
When the housing is powered on, touching the gold water sensor (located on the inside bottom right of
the housing) will cause the Leak Alarm to activate. If that happens, power the housing Off and On again.