4. MAINTENANCE
WARNING! With the exception listed below, all pump, float and electrical cable service, maintenance and repair must only be
undertaken by an authorised service agent. Failure to observe this rule may be dangerous and will invalidate your warranty.
WARNING! Ensure the pump is disconnected from the mains power supply before attempting any service or maintenance.
4.1.
Keep all parts of the pump clean. rinse, drain and allow to dry before storing pump.
4.2.
regularly check the water inlet on the base of the pump to ensure there are no blockages. To access the impeller carefully undo the
four base hex headed screws and remove base. clean the impeller and replace the base ensuring that the o ring is correctly located.
DO NOT
dismantle any other part of the unit.
a.
Motor operates but
there is no suction.
b.
reduced water
volume for level
of water
c.
The pump will not
start or suddenly
stops during
operation.
1.
no electrical power.
2.
float not working.
3.
Impeller is jammed.
1.
check cable, plug and fuse.
2.
contact authorised service agent.
3.
clean the pump.
1.
Discharge pipe bent, or pinched.
2.
Discharge pipe too narrow.
3.
Pump partially blocked.
1.
Straighten pipe.
2.
use wider diameter pipe.
3.
clean pump.
1.
Water level below min suction depth.
2.
Air bubbles in pump accumulated during submersion,
or float is incorrectly positioned so pump does not stop
at minimum level and sucks in air.
3.
clogged intake filter or discharge pipe.
1.
Stop the pump.
2.
release air by inclining the pump and
re-immersing it in water.
3.
remove blockage, and clean the unit.
TROUBLESHOOTING
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
no liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7Ar
www.sealey.co.uk
Web
Original Language Version
© Jack Sealey Limited
Environmental Protection.
recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment.
Parts support is available for these products. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.
NOTE:
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of
experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible
for their safety. children should be supervised to ensure that they do not play with the appliance.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance with the Eu Directive on Waste Electrical and Electronic
Equipment. When the product is no longer required, it must be disposed of in an environmentally protective way.
contact your local solid waste authority for recycling information.
WPS250A Issue: 1 - 22/01/14
