sealey Group, Kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7ar
01284 757500
01284 703534
www.sealey.co.uk
eNVirONmeNt prOteCtiON
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
weee reGulatiONs
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note
: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
4.2.
regularly check the water inlet on the base of the pump to ensure that there are no blockages. to access the impeller, carefully undo
the base hex headed screws and remove the base. clean the impeller and replace the base ensuring that the o ring is correctly
located.
8
DO NOt
dismantle any other part of the unit.
6. trOublesHOOtiNG
a.
motor operates but
there is no suction.
b.
reduced water
volume for level
of water.
c.
the pump will not start
or suddenly stops
during operation.
1.
no electrical power.
2.
float not working.
3.
Impeller is jammed.
1.
check cable, plug and fuse.
2.
contact authorised service agent.
3.
clean the pump.
1.
discharge pipe bent, or pinched.
2.
discharge pipe too narrow.
3.
Pump partially blocked.
1.
straighten pipe.
2.
use wider diameter pipe.
3.
clean pump.
1.
Water level below min suction depth.
2.
Air bubbles in pump accumulated during submersion,
or float is incorrectly positioned so pump does not stop
at minimum level and sucks in air.
3.
clogged intake filter or discharge pipe.
1.
stop the pump.
2.
release air by inclining the pump and
re-immersing it in water.
3.
remove blockage, and clean the unit.
prOblem
Cause
sOlutiON
Original Language Version
WPC100.V2, WPC100A.V2, WPC150.V2, WPC150A.V2, WPC235.V2, WPC235A.V2, WPC250, WPC250A Issue: 3(L) - 25/10/17
© Jack sealey limited
