NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
S
ole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
01284 757500
01284 703534
Web
V
S402.V3 | Issue - 1 14/09/16
Original Language Version
© Jack Sealey Limited
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
8.3.4.
Operate vacuum pump until approximately 21inHg vacuum is created.
8.3.5.
Apply copper grease to the brake bleeding nipples before and after the brake bleeding procedure to reduce the possibility of seized or
broken nipples when the brakes are next bled.
8.3.6.
Open the bleed nipple about a quarter of a turn. Allow brake fluid to be drawn until no air bubbles are visible in the brake fluid in the
clear hose.
8.3.7.
Tighten the bleed nipple.
8.3.8.
Remove the attachment from the brake nipple.
8.3.9.
Repeat the process as necessary.
NOTE!
Check the master brake fluid reservoir regularly to ensure that the level does not drop too far, and top up as necessary.
NOTE!
Empty bleeder container regularly and
DO NOT
allow container to overfill as brake fluid will be drawn into vacuum pump.
WARNING! When brake bleeding and/or fluid changing is complete, test the action of the brake pedal to ensure that the brakes
are working before attempting to drive the vehicle on the road and test the vehicle for satisfactory performance of the braking
system.
8.4.
Clutch Bleeding Procedure.
8.4.1.
Refer to the relevant vehicle manufacturer’s instructions for clutch bleeding procedure. If no specific instructions from the vehicle
manufacturer exist, follow the same basic procedure as the brake bleeding instructions above.
fig.15
fig.14
fig.15
